insize

Supplied with limit pointers and bezel clamp Optional accessory: backs (page 101), contact points (page 98~100).

Shockproof Jeweled bearing Supplied with limit pointers Optional accessory: backs (page 101), contact points (page 98~100).

Carbide measuring faces Meet DIN863 Supplied with setting standards (except 0-25mm).

IMPA code 650471

Micrometer head accuracy: +/-3μm Rod accuracy: +/-(2+L/75)μm, L is the measuring range in mm Rods with flat end Ratchet stop.

Carbide measuring faces Meet DIN863 Ratchet stop Supplied with setting standards (except 0-25mm).

Carbide measuring faces Meet DIN863 Supplied with setting standards (except 0-25mm).

Carbide measuring faces Meet DIN863 Supplied with setting standards (except 0-25mm).

Measure wall thickness of tubes Ratchet stop Carbide measuring faces Supplied with setting standards (except 0-25mm).

1mm feeding of each turn Friction thimble Carbide measuring faces Meet DIN863 Supplied with setting standards (except 0-25mm).

Measure the height of crimp contact Resolution 0.01mm Ratchet stop

Used as Go/No-Go gauge by setting upper and lower limits Carbide measuring faces Supplied with setting standard (except 0-25mm).

Measure the outside diameter of cutting tools (such as taps, reamers, end mills) with 3 or 5 flutes Ratchet stop Carbide measuring faces Supplied ...

Meet DIN863-4 2-12mm: graduation 0.001mm 12-300mm: graduation 0.005mm Ratchet stop Optional accessory: setting rings (code 6312), micrometer stan...

Carbide measuring faces Ratchet stop Setting rings are included (except 200-300mm).

Measure the groove diameter of shafts and keyways Non-rotating spindle Ratchet stop Supplied with setting standards (except 0-25mm).

Measure thickness of disk brakes Ratchet stop Carbide measuring faces Supplied with setting standards.

Ratchet stop Carbide measuring faces Supplied with setting standards.

Anvil retracting range: 8mm Carbide measuring faces Supplied with setting standards (except 0-25mm) Optional accessory: dial indicators (graduatio...

Ratchet stop Carbide measuring faces Supplied with setting standards Optional accessory: dial indicators (graduation 0.01mm), digital indicators (...

Το Μικρόμετρο σπειρωμάτων είναι ένα εξειδικευμένο εργαλείο μέτρησης που χρησιμοποιείται για την ακριβή μέτρηση της μέσης διαμέτρου (Pitch Diameter)...

Τεχνικές Προδιαγραφές Εύρος μέτρησης (εξωτερικό A): 0–150 mm (ανάλογα με το μοντέλο) Εύρος μέτρησης (εσωτερικό B): 1.6–151.5 mm (ανάλογα με το ...